Question about Goodman Heating & Cooling
goodman gmt070 inductor fan clicks on, pilot glows, nothing Inductor fan clicks on, pilot glows, nothing happens. Then it repeats the above cycle & ignites. Possible bad igniter...igniter should read ...
...not ignite I have a Gmp100-3 the igniter will not glow. the system wil try to start the fan starts there is a noise (that used to be when the ignitor woud start) i smell gas and then nothing it does ...
...not ignite, Please check the ignition transformer. This have a secondary voltage of about 20,000 to 25,000 volts, enough to make your igniter spark, thus, causing the atomized fuel to ignite and burn ...
Question about Desa International Heating & Cooling
...not ignite. Now you may want to try to reposition your igniter closer to the fuel source. I have also widened the spark gap on the spark type igniters and had success. Then are you sure that the ...
rinnai gas heater not staying ignited following the normal start up process the heater shuts down once the ignition button is release after the heater appears to have ignited. It remains ignited and ...
...I replace the circuit board, or is there anything else I should check? Thanks! Make sure you are not getting 110 volts at the igniter before you think about replacing the board. Igniters are a ...
...not ignite Hi I have a MHU45LP and it worked fine. But now it will not ignite I changed the igniter, flame sensor and even swaped the board out. The gas comes on and still no heat unless I lite it ...
this problem could be from having dirty burners or ignitor not position to ignite the gas right away or your ignitor may not being glowing enough to ignite the gas being released, check all, Good luck
...ignite the gas but it does not click. Does that mean that the module is bad or the igniter itself bad? The igniter has zero ohms of resistance when I put a meter to it and I don't see the 24vdc when ...
Question about Heating & Cooling
...come on Could be a weak igniter, it the igniter does not get hot enough it will not ignite the gas. Make sure the gas valve is opening to allow gas to the burners, if not the gas valve is the ...
389 questions posted
Usually answered in minutes!
354 Questions
85 Questions
73 Questions
62 Questions
44 Questions