...dyna-glo pro we have three dyna glo pro heaters { model # RMC-KFA170TDGP, we need filters for them, but can not find them. we do not have our manuals, and when we went to home depot, they no longer ...
...Dyna glo wall mounted heater I would check the flue out side first to make sure it is not blocked. If flue looks good i would try cleaning or replace thermalcoupl. Most of the dyna glo heater i have ...
dyna glo ventless rmc50 ngt can this heater be changed from natural gas to propane use, a local heating shop told me it cant be done All gas heaters can be converted from one type of gas to another, ...
Question about Dyna-Glo Heating & Cooling
...Dyna glo gas wall heater -model RMI-70LP) Both repairable and dangerous. The burner need blown out with a air compressor. This should take care of it. The unit not glowing red will create CO. Which ...
Question about Dyna-Glo Heating & Cooling
...dyna glo) 3 years old, pilot light will not light, get good spark but will not flame. Checked all connections from tank to heater-no problems, propane not coming thru heater to ignitor. What do I do? ...
Question about Dyna-Glo Heating & Cooling
...dyna glo needs a new thermocoupler,where to get one, it is armc-50 ngt,lpt-30000 btu/hr thermostat These thermocouples rarely go bad. The oxygen sensing pilot will get dust in it and shut down making ...
Question about Dyna-Glo Heating & Cooling
dyna glo roc kfa 120 forced heater Replaced 4 amp fuse(twice). Every time on button is turned on, fuse blows. Because there is a fault in the unit, time to get it repaired assuming that is the correct
dyna-glo rmc tt30dgp wont turn on i have a dyna-glo tank top heater that worked fine for a while then the on dial started getting hard to turn. I now can not turn the dial to any position; low, med, ...
Question about Dyna-Glo Heating & Cooling
...Dyna-Glo heater model RMC-95-C4 was not burning correctly so i replaced the wick and now when i lite it it smokes on hi and burns very hi on low. Is there something I need to adjust? The wick is too ...
Question about Dyna-Glo Heating & Cooling
dyna-glo wall gas heater. Set screw for what? To raise the flame? Not one. What you gotta do is clean out the pilot. Least bit of dust makes the safety think oxygen is low and shuts down the heater. I
389 questions posted
Usually answered in minutes!
354 Questions
85 Questions
73 Questions
62 Questions
44 Questions