...igniter. The flame seems to "roll back" when it first kicks on. This only seems to happen when it is below 30 degrees outside. Your GMS unit should not be intermittent ignition but direct ...
Question about Heating & Cooling
8" yellow flame shooting out of ignition tube when running. No adjustments that I can see on the (Honeywell) gas cut off/pilot valve. Pilot works as expected and burners seem to light and hold as ...
m55 flame does not ignite Ready Heater M55 flame does not ignite. When turned on the fan starts runs for 10 sec and then the unit shuts off. The flame never ignites. propane heater or kerosene?
...flame, check igniter: after unit is turned on, the igniter should get hot - CAREFULLY feel the area where igniter is mounted to burner. If it's not hot, your igniter is bad, needs replacement. If you ...
...igniter gets hot enough, it sends a signal to the module opening up the gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a ...
...75,000 BTU furnace has three in shot burners with a HSI located in the right hand side and the flame sensing rod in the left hand side. The only burner that ignites is the side with the HSI
...flame sensor be part of gas valve,on other side of plate,in chamber,but not in flame? Flame sensor is part of the igniter and may need to be cleaned up. To much build up will cause this
...igniter gets hot enough, it sends a signal to the module opening up the gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a ...
Question about Heating & Cooling
...igniter and sensor. After he left I looked for the flame and only see flame shooting toward back of unit?Is this correct? It sounds like he incorrectly installed the igniter and it may be a huge ...
389 questions posted
Usually answered in minutes!
354 Questions
85 Questions
73 Questions
62 Questions
44 Questions