...door. Unfortunately it requires replacing the full fuser and it's expensive. Approx. $170.00. I know the news is not good but hope it helps you. Call Brother if it's still under warranty! If not, ...
Question about Brother HL Office Equipment & Supplies
...fuser roller, open the back door and try to see the upper fuser roller and lower pressure roller if you see any wrinkles or damage in any of the rollers that's is the problem, you can replace them ...
...door, you can view the fuser. The part your looking at is the orange roller. It will either be wrinkled, ballooned, or separating the outer clear sleeve from the inner core. The last one is a little ...
Question about Brother HL Office Equipment & Supplies
...door there are levers on each side to release pressure on the paper if it's in the fuser. With the toner and drum out, you can see up to the input to the fuser, and from the back is the output from ...
Question about Brother HL Office Equipment & Supplies
...to make a test print before the paper hits the fuser area and open up the door, this will cause a paper jam, but you can see if you are getting the speckled print before it hits the fuser. thanks ...
Question about Brother HL Office Equipment & Supplies
...door and check for paper. 2: If no paper is present pull down on the output assemble and check for paper there. 3: When you pull down on the fuser output you should see a long thin piece of plastic ...
Question about Brother HL Office Equipment & Supplies
door and lookat the fuser roller, you may have to cycle power to see all of the roller, otherwise you unplug machine when paper is partway thru and see if it's on the print before the fuser. Spots are
Question about Brother HL Office Equipment & Supplies
...door to stop the printing. It wont hurt anything but will allow you to see the end of the sheet before it goes to the fusing unit. Of course you need to be very careful removing the sheet to prevent ...
Question about Brother HL Office Equipment & Supplies
fuser (hotbit). Once you have mastered the position correctly by stopping the printing by opening the door and removing drum/toner cartridge, to reveal the paper that is printed but can be rubbed off,
...fuser problem but you can check by opening the rear door and looking for two rollers that are about as thick as two fingers and see if they roll during a test print. Sometimes the gear on the fuser ...
21 questions posted
Usually answered in minutes!
1,072 Questions
495 Questions
422 Questions
377 Questions
249 Questions