...feed or manual feed Push the copy button with the cover up and no paper on the glass. Is the light bar straight up and down, or is it crooked? I can't imagine how paper could go thru the machine ...
...manual feed tray and one for the paper drawer. If you look at the front of the paper drawer, you will see a spring loaded friction pad in the centre used to hold back all but one sheet of paper. ...
...soap. Damp a rag with it, and reach in there to clean the rollers. See if the rollers will turn manually, but be careful not to force anything. Another way to get to the whole roller, would be to ...
Question about Dell Office Equipment & Supplies
...Instead it says there is no paper in the tray. Sometimes, if I take a single sheet and feed it manually as it is trying to print, it will grab it and print. I have looked inside and don't see ...
...grabs, it will only feed a short distance as it catches on the teeth inside the machine and won't go any further. I don't think I can load it via the tray as it's 350gsm and won't take the bend ...
...from Canon, but cannot go to step 6 since will not grab paper. And, have tried a q-tip to clean manually. Only using letter size printing paper and lever to left. Tried all suggestions from ...
...message I get is "out of paper" when in fact it is not out of paper. I can take the tray out and manually feed a single sheet without a problem, when the tray is installed, if I force the paper ...
manual feed slot. 7. Turn the printer off. 8. Take a #10 envelope and feed it through the left side of the manual feed slot until it comes right through the printer to the back of the exit rollers. 9.
Question about Office Equipment & Supplies
...manual feed, then shows Paper Jam and stops feeding paper any further. I've used canned air, turned rollers on bottom inside-out and shaken printer while upside down (it, not me!). Any other ...
Question about Brother MFC Office Equipment & Supplies
...Z52 printer properly. The roller doesn't seem to grab the paper unless I move the paper down manually. try to replace feed roller might that roller already worn
843 questions posted
Usually answered in minutes!
1,135 Questions
1,012 Questions
743 Questions
406 Questions
381 Questions