Hotpoint Aquarius WD63 Front Load Washer/Dryer "ultima loose drum" Questions

loose drum Hi I have a reasnobaly new hotpoint super silent ultima machine. During the spin cycle its so noisy and loud you have to leave the room, the feels that it is slightly loose as when you move

...ultima, very noisey when on spin Remove lower rear panel of washer, remove belt and spin drum by hand, if it is noisy or feels rough, then main drum bearings have failed. If no noise, then look ...

...drum inside has came loose so i took the top of to have a look and there seems no way in to tighten it up the only way seems to lift the whole drum assembly out some how what do you think There is no ...

...goes to 1 minute and then does no more. If you open the door and turn the drum manually there is no friction and is free to turn. Thanks for your help. I THINK IT MUST BE A LOOSE COIN,STUCK IN ...

...drum was loose! My neighbour (always one never to be defeated by a problem) found it by chance when he felt under the drum. Three bolts were all loose. Hopefully it is bad assembly and will not come ...

loose. When the drum is turning slow it seems to go side to side as well as rotating. When the spin initially starts the drum seems to bang on the sides of the unit sometimes making quite a loud noise

drum 'loose'. However, these bolts can't be tightened up anymore, suggesting they are fully home. Having removed the bolts and then block, I can see the three supports are badly worn (presumably where

loose, and that the dampers are not broken or worn. Please rate my solution. Thanks. i have a hotpoint ultima wt640 it has a slight squeek on spin but noise is coming from front of machine around door

ultima wmd940 washing machine after replacing the drum bearings, machine starts to fill and when it gets to the time when the drum should start turning im getting an error code F:10, have switched off

...loose and rattling ultima extra wma64 drum is loose and rattling Your bearings have broken up in the drum. This is a very difficult DIY fix since it involves stripping the front from the machine, ...