base bracket. You will need a long phillips to get to the 3rd screw. Slide out the base bracket. Flip the panel over and stare at the lcd with the buttons side on the top. Grab a small flat head screw
base bracket. You will need a long phillips to get to the 3rd screw. Slide out the base bracket. Flip the panel over and stare at the lcd with the buttons side on the top. Grab a small flat head screw
...base, four phillips head screws. 2) remove the back, five phillips head screws. one in each corner and one behind the base mount, thus the need to remove the base. 3) carefully pry off the back, it ...
...phillips head screwdriver to unscrew these screws. There will be some on the top, bottom and possibly on the sides. Take out all of the screws and then the back should come right off. The screws are ...
base bracket. You will need a long phillips to get to the 3rd screw. Slide out the base bracket. Flip the panel over and stare at the lcd with the buttons side on the top. Grab a small flat head screw
...phillips screwdriver and a 5/16" open end wrench to tighten up some nuts inside the plastic housing. The plastic housing doesn't come off with the screws, but has to be slightly pryed up to release ...
...base arm to the screen. Remove those and the arm will come off. Now, on the bottom right, there is a beveled slot where you can fit a flat bladded screw driver to start to snap open the case. Move ...
Question about ViewSonic Computers & Internet
...phillips screw driver set, nutdriver for removal of VGA and DVI locknuts/capstands, cuticle scraper for removal of internal connectors and monitor case clips and a "Bennifiber" measuring scoop (to ...
63 questions posted
Usually answered in minutes!
5,069 Questions
2,066 Questions
1,757 Questions
1,195 Questions
1,096 Questions