...door securely closed, remove the two screws that hold the front panel in place. There should be one screw on the interior cabinet on either side. Position your body to hold the panel in place as you ...
...removing the two 10-mm screws attaching it to the rear of the dryer then slide the cover rearward and lift it off the dryer cabinet. Take note of the notch in the top cover engaging the screw on the ...
...door opening. Pull the front panel forward and disconnect the interior light wiring harness then lift the front panel off the tabs across the bottom and move it away from the dryer. Reinstall the ...
interior. 5. With the door shut, lean against the front panel and remove the two screws that hold it in place. Once the screws are removed, grasp the front panel at the top center and lift straight up
...removing the belt from the motor pinion. Older GE dryer models have a small drum bearing inspection plate in the center of the back of the dryer. This drum bearing inspection plate provides access to ...
...door by inserting a putty knife along the seam (about 2 inches in from each side) to depress the release clips. 3. The heating circuits are located on the right hand side under the drum. If you need ...
...door switch connector and any ground wires that may be attached to the front panel. Then, remove the panel screw on each side that holds the front in place. With the screws removed, the panel will ...
...door. The access screws are located under the bottom front edge of the panel. You may have to prop the two front feet of the washer up for better access ( a 2x4 works well for this). With the screws ...
...door area and the four screws from the top of the front panel and attaching it to the dryer cabinet. Pull the front panel forward then disconnect the interior light harness. Lift the front panel off ...
87 questions posted
Usually answered in minutes!
195 Questions
109 Questions
28 Questions
31 Questions
25 Questions
