Gateway FPD 1830 18.1" Flat Panel LCD Monitor "f1 fuse replace" Questions

...fuse f1 had gone open circuit. I have replaced it with a 4 amp quickblow fuse. Have you got a circuit sheet for this monitor. I want to check its value for the fuse f1/ mine had the same problem, ...

...fuse is "F1". How can I make sure it's a fuse? Thanks. Comon problem with this model are the 4 bad caps (100Uf) on the inverter board, they developem high ESR and you must replace them with FM/FC ...

...fuse on the inverter board. Check fuses F1 and F2. These are Fast Blow 2.0 Amp surface mounted fuses, case style 1208. Available at Newark Electronics, part number 64R8010. They are located on either ...

...fuse F1 and just to the left of the small round coil L856. My R1 is smoked beyond recognition. Thanks. did you measure yours? mine measured 4.48K - makes me think 4.7 K ohm. I wish i knew for certain ...

F1 Fuse on the LED control board is good. -The standby pin in the power board is getting 5v -The main board is getting power because the heat sink is getting hot -CN25 on the main board is getting the

...also and carefully tilt it up. Observe tiny chip fuse (referenced F1 or FU1 or something with "F") somewhere nearby the connector, ring it, replace it with solder drop. Take everything back

...fuse is labeled F1 on the circuit board and is marked FT on the fuse itself. Thanks! You can try this, solder in a 1/2watt 1 Ohm flame proof resistor (MOX, Metal Oxide) in place of the fuse (a lot of ...

...fuse on the inverter board. There are two fuses, F1 and F2. Either one can fail. The fuses are located on either side of the CN1 connector. These fuses are 1.5 mm long, 1.0 mm wide and 0.5 mm high ...

...long thin board, similar to the one below. This may need to be replaced or you may get lucking and just be able to replace the F1 (fuse) component and fix it. (or have a techical friend do it for

...fuse labeled F1, right next to the capacitors. with power plugged in you should read 12volts on both sides of this fuse, if not it is bad and is probably the problem. solution is to just connect both ...