Sony Handycam CCD-TRV40 Camcorder "removing jam tape" Questions

Inserting tape into camcorder When I put a tape in the camcorder and close the compartment, the tape will not retract within the camcorder. The motor runs but the tape will not go down. When I remove ...

...removing after open to change cassate. it does not come out.what should i do These mino tape cameras unlike the larger 8mm tape camera have never worked well because they jam in-side the capstan and ...

can not eject tape I have a Sony TRV-16 that had a tape stuck in it. I tried to eject it and the tape only came out half way. I turned it off and tried to eject again but the tape went back in the ...

...removing the battery pack and reconnecting the power source. It didn't work. Any suggestions? Thanks! I had the same problem (error c:32:00, beeps and tape would not eject. Cassette was halfway ...

tape ejects a third of the way and stops Everything is functioning ok on the camera, but I cannot get the tape to eject all the way out. The tape comes about a third to a half way out, stops, then ...

I have a handycam DCR-HC18e. The nightshot plus slider is set at off, but is still on as shown on the screen when I switch it on, and from the overexposed look of the recording....any suggestions? ...

tape in it. I have tried removing the battery for a while and then replacing it. It just seems like it is jammed. Any ideas on how to fix this? Is it even worth getting someone to repair it? Thank you

jammed by putting tape in upside down I inserted a fresh tape upside down in my Sony Handycam Hi8. The cassette went down OK. I realized a problem when top didn't re-close completely...off a 1/8". ...

DCR TRV320 Hi! I have DCR TRV320. The problem is that I put tape in (it works fine) but after a few seconds it ejects it showing error c31:10. I tried different tapes - same result. That is the "LOAD"

Can't open door - can't eject tape The camera side door will not open. I have even taken the outer door off to see if there is a level or something. I cannot get the mechanism to move. It is as if it ...