Hotpoint FFA90 Bottom Freezer Refrigerator "heater fan caution" Questions

be traced to one of three things. The fan or blower The timer device The electric heater coil By methodically checking these parts you can isolate your problem and fix it. I hope this will help out...

...fan assembly which addresses the problem. Our was replaced under warranty, and the problem has gone away. I think the new panel has some kind of heater strip to prevent ice accumulation. There are 2 ...

...fan. At this point, you need to be sure you are confident in proceeding further. Once the cover is removed, you will be where electrical and mechinical things happen. Be sure to unplug the unit!! ...

fan is defective, it will prevent proper cooling as well. This will conclude the most common issue with a under preforming unit. I would advise to check all the above and, if the unit continues to not

HEATER (or flow reversal valve) inside to generate heat... All with their OWN defrost thermostat... to keep them from getting VERY warm... Hot is a problem... Very likely with that DEFROST THERMOSTAT.

heater If it still does not cool properly, there may be a problem with the refrigerant level or the compressor. You may need to consult with a qualified appliance repair technician to further diagnose

...heater to check these components .... please refer to my solution in the below link.... http://www.fixya.com/support/t4189238-defroster_not_working_checked_defrost If it still does not cool properly, ...

...fan will come on that blows the cold air up into the ice compartment. Another clue was that I believe that the first time this happened I had too many things crammed into the back so that it was ...

...heater Test defrost timer Test evaporator fan Check for a clogged drain tube Check for refrigerant leak if its just like u said its a eveporator fan issue foolow me to how to test it: Caution: Please ...

...fan is not your problem. MODULAR CONTROLS An icemaker's motor and switches may be in a module that must be replaced as a unit if any one part is bad. Holes in the module let you test the parts. ...