Hotpoint HSS25GFP Side by Side Refrigerator "cubes releasing bin" Questions

...bin. After I tore it apart and put it back together the arms moved and then froze in the middle of the cubes and would still not release the cubes. Sounds like it is time to purchase a new ice ...

...bin,put the remaining cubes in a bucket,or toss,then check the ice auger in the bin and if theres a build-up of ice melt it with hot water,then thoroughly dry it,then replace this unit into the ...

...bin. i can dump in myself and it re fills water, but the cubes just stay in the maker and wont alow the next batch to be made. Your trouble can be in the icemaker. An internal thermostat closes to ...

ice won't come out of door, no motor noise Ice cube are made and released into holding bin, but won't come out of door when lever is pushed Make sure the holding bin is in its proper place

...to cubes leave the bin out push the light switch in and hit the  dispenser button you should hear a loud pop and see the actuator by the auger motor move up,and drop down when you release

...cubes & crushes. When on cube it crushes and when on crush it crushes. Remove the ice bin. Look at the back wall, behind where the bin was. You should see a rectangular hole, about 1.5 x 1 inches ...

...bin that holds the cubes,it may just have moisture (ice)built up in it,you can loosen it up with a hair dryer on low setting, Don't pry on it too hard that bin isn't sold in pieces anew one runs $100 ...

...cubes, only crushed ice, when on either the cube or the crushed ice buttons. check to see if you ice bin has full size ice cube in it... if there is then you dispense is stuck in the crush mode check ...

...cubes are not dropping into the bin The evaporator system that release the ice is not working, test evap fan and motor , and test the heating coil on icemaker evap system. Enter the model number on ...

...cubes, only crushed ice. take out your ice bin the look in the back of the freezer and ytou will see a small hole with a plastic sqaure actuator.hold the door switch closed and make sure the unit is ...