...in and out? you mean needs to be reset often? or does switch actually fall in and out of unit? EITHER way replace it. It is a VERY important safety, and if not working100% can cause fire/injury or ...
...Reset button on rear in a hole or the control unit has to be in the grooves on the rear of the fryer and pushed all the way down. there is a safety switch in the groove on the control unit. Hope that ...
Question about Star Kitchen Appliances - Others
...reset button on back side of fryer This button should be a high limit switch. If it is a small red button mounted to a 2" x 2" or so device. You most likley have an issue with the thermostat letting ...
Question about Kitchen Appliances - Others
...reset button trips on low oil temperature, check and make sure that its sensing bulb located inside the fry tank does not touches the fire tube. This device is called the hi limit, it is the ...
...button on the back, down in a hole. My reset button is red. Also there is a safety swith on the rear where you slide the control unit into the grooves, it has to be all the way down for it to
...reset button. Any advise its safety switch not functioning my Adcraft deep fryer needs 2 switch 2 thermostat where do i get parts .I was using it and fire came from it it stop work the ...
...have to push the reset button to make the deep fryer work again the the safety its pretty common on deep fryers with out that man i would be in trouble i leave mine on sometimes so its not a bad ...
Question about Lang Manufacturing Kitchen Appliances - Others
...reset there is a good change your fryer has a shunt trip safety. If you still have the manual it will help greatly. If not you can go on line and find the manual with a troubleshooting guide. Good ...
Question about Kitchen Appliances - Others
...reset button is probably a high limit. The high limit is a safety device to turn the fryer off if the oil gets too hot. Normally they will "trip" somewhere between 375 - 450 degrees F for commercial ...
Question about Pitco Frialator Kitchen Appliances - Others
The burners will not light. The pilot does light. I had my staff try to hit anything that looked a reset, but I don't know if the high limit switch has a reset or if the switch itself is bad. The ...
9 questions posted
Usually answered in minutes!
21 Questions
18 Questions
9 Questions
3 Questions
2 Questions