Magic Chef CMV1000B Microwave Oven "solder point back" Questions

...back the two printed lines to the originating points on the hard board of the microwave. Get two insulated wires soldered to these points and solder the other ends of the wires to a mechanical push ...

...solder point or the relay on the piggyback board on the back of the control panel but do not know how to check it. From the poorly solder points it appears to have been previously replaced. Would the ...

...Open cover, follow power cord to a small cylinder about 3 milimeters across. It is pointed on one end. Cut it out and take to an appliance repair store. solder the replacement thermal fuse back

point. It sounds like there may be a blown fuse. The back of the mw oven will have to be removed to check. Some ovens only have a thermal fuse and not a traditional glass fuse. If that is the case you

...Solder the other end toa well insulated contact point as a #14bare copper wire about 2 inches long and secure the resistor to a piece of 2ft pvc pipe with electrical tape clip the other end of the ...

...back of the switch assembly. If visible, you may be able to replace it. These generally can't be fixed with any kind of contact cleaner because of the way they are built. If you decide to try it, you ...

...back again and then goes dead again. The inside door mechanism seems to be intact and no physical appearance of any damage ProLine ST44 950 Watts Microwave Since this machine is only sold in the UK I ...

solder at a point where the cap meets the body of the fuse. If the fuse blows as soon as you plug the oven in the wall, or when you open the door, the problem is likely with the door switches. You can

...solder at the point where the end cap meets the body of the fuse. You can use a generic holder - it's a lot cheaper than an OEM part. The connectors should be 1/4" tabs and it should be rated at 20 ...

...solder at the point where the end cap meets the body of the fuse. You can use a generic holder - it's a lot cheaper than ordering one. The connectors should be 1/4" tabs and it should be rated at 20 ...