Miele WT945 Front Load Washer / Dryer "circuit board" Questions

...circuit board and the motor or motor control board. The CCU circuit board (inside back, top of machine, plastic case) has what's called cold solder joints where the relays (5 of them) and the spade ...

...Circuit board end connections be reversed? When the whole train is connected and running, the Bakery Car display is on the wrong side of the train! The Wiring harness set-up, Male on one end, Female ...

...circuit board and the MCU circuit board. The problem is most likely with the CCU circuit board (inside, top, back, plastic case) There are bad solder connections where the relays (5 of them) and the ...

...circuit board on hotpoint aquarius wf440 ? New circuit board How to put in the circuit board on hotpoint aquarius wf440 ? this may be of some help good luck otpoint control module configuration for ...

...circuit board. There are bad solder joints on the circuit board (also called cold solder joints) where the spade connectors and relays (5 of them) are supposed to be securly soldered to the board. ...

...circuit board and the Door lock, it thinks there is problems with the lock so it stopped working. The communication error is most often on the CCU circuit board. The CCU has bad solder joints (called ...

...circuit board in the machine (inside, top, back, plastic case) The CCU circuit board has what's called cold solder joints causing bad communication between the CCU and the door lock and/or the motor ...

...circuit board where the relays and spade connectors are connected to the circuit board. You'll need to remove the circuit board and touch-up those connections or have a good appliance repair shop do ...

...circuit board.I'm assuming it is a main panel circuit or the circuit/panel board in front. What would I need to test to see if the main panel/circuit board is faulty? I had assumed that the front ...

...circuit board. Give the screwdriver a slight twist with one hand and gently pull up on the circuit board with your other hand. Repeat this process along one side of the circuit board, one tab at a ...