Poulan PP3516 "chainsaw engine cuts trigger" Questions

chainsaw trigger will not fully engage the carburetor, so I cannot use a moderate cutting speed for cutting. I have heard there is a spring, but I cannot figure out how to open the housing up,,..where

chainsaw it will start up and run as long as i keep my finger on the gas trigger but when i take my finger of the trigger the engine die cut off what could be the cause how can i fix it. Try adjusting

engine starts cuts out when trigger squeezed engine starts stalls out when trigger squeezed plugged fuel filter or bad gas

Stihl chainsaw oiler adjusting screw what all parts are involved with this, can you get a breakdown and where? engine starts and runs but whan trigger is pulled to max it cuts out

...engine has good compression crank casing seals are in good condition never have your body in line with the chain it could run off the bar at startup ..flick .onto your arm or face choke on trigger ...

...chainsaw won't start What is the procedure to start this. It is driving me nuts! 1st add fuel/oil mix to fuel tank , then top off oil tank with bar oil , place saw down on flat surface , press 'ON" ...

...chainsaw which can make the bar hit dirt and your chain will get blunt!!! or your leg but that wont blunten the saw 9.keep pulling the cord until you hear the engine fire, Probably 3-5 descent pulls, ...

...chainsaw. I can get it to start and stay running as long as I have the choke on. I can even run it at high speed using the choke control. When I pull the trigger to feed it gas it starts to stall. I ...

...engine will die unless I continuously pump the gas trigger. Ted The carb low idle needs to be adjusted this is fairly common among the Poulan chain saws. Once you adjust the low idle from factory ...

...trigger it revs up to 1/2 to 3/4 throttle and starts cutting out. I have replaced new gas with correct oil mixture, replace spark plug, fuel filter, carb and adjusted carb. Cleaned spark arrester and ...