one cylinder not firing First take the plug wire off the plug to the one not firing..start and then using a pair of pliers hold the plug wire away fro the plug insert a rubber handled screw driver in ...
Question about Tecumseh Tools & Hardware - Others
...HS50-67124C SFR 1131B Hello: Operate the Engine Unitl it Quits and then Check for Fire to the Plug. If No Fire, then the Ign Coil/Module Requires Replacing. Hope this Helps. Good Luck Respectfully ...
Question about Briggs & Stratton Tools & Hardware - Others
fire to spark plugs, sat up for 6 mos, drained fuel prior to setting up Remove the wire that runs between both coils and try it again.If it starts you have a bad diode wire or a short to ground in the
...What should I do? try running the engine for 10 minutes then remove the drain plug. The sump oil is burnt to almost tar from lack of service or badly worn rings allowing combustion fire into the ...
Question about Poulan Tools & Hardware - Others
the spark plug is firing and is getting gas but won't start It sounds like you have low compression in the engine. I would check the compression it should be 100 psi.
Question about Briggs & Stratton Tools & Hardware - Others
...fire after ensuring all Leads are OK, the Spark Plugs are proven OK, the Cables, the Points, & Distributor, . IT is either that or the Ignition Timing is OFF. Please check all those points. ...
Question about Tecumseh Tools & Hardware - Others
...engine (even covered). Try removing the plug and drying out the cylinder (compressed air blown into the cylinder usually works.) With the plug still removed pull the cord a few times andf try to get ...
fire, would not start...Did compression test, got 60 lbs. on first pull, 90 on second Often the cause is a failed fuel pump diaphram. Rebuild the carb... kits about $20. The diaphram works from engine
Question about Briggs & Stratton Tools & Hardware - Others
...plugs. This can be done by removing the spark plug lead and putting another spark plug. Crank the engine and see if it firing. Reason because ignition coils when failing they will normally tip start ...
Question about Briggs & Statton Tools & Hardware - Others
...fire off the engine, spark plug cannot be removed from whatever it it connects to will not fire off. Spark plug cannot disconnect fron the wiring that it pushes into. it appears that section must be ...
9 questions posted
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions