oil will burn the bar and chain because it39;s to light.Tighten chain so you can pull chain 1/8 inch from bottom of bar then pull spark plug cover off to the side and screw driver cross ways to pull
...oil tank before storage, I can39;t see how you would remove all residual oil from the pump, tubes etc as they39;re very narrow, and so I can see the problem occurring again. I was wondering ...
...39;t fire the pkug,but it will fire a tester it just quit after sawing through a log. As soon as I let of the gas it quit and would not start. I spark tested it and it lighted up the tester. I put a ...
...39;s when I saw the gas had no oil in it). Ran hardware wire through all of the fuel lines. Replaced the fuel filter and spark plug. Cleaned the air filter with a nylon brush and compressed air. Same ...
39;s side so the bar is up. 3. Remove the 2 nuts holding the side plate on the saw. 4. Remove the side plate and the bar and chain. 5.
Question about McCulloch Garden
...39;t start has run before put in new plug ran for 2 min would not restart Hi Burt597Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are ...
11 questions posted
Usually answered in minutes!
311 Questions
93 Questions
31 Questions
30 Questions