Husqvarna/jonsered 136-142,2036-2137 Clutch "chainsaw wont pull" Questions

...chainsaw wont start when hot My 3 week old Maculloch chainsaw wont start when hot I suspect your warm start procedure is the fault, the manual is not correct IMO. Any choke on a warm engine causes ...

...chainsaw pull cord wont pull start I pulled cord a couple times (wasn't to easy) and on the third pull I couldn't budge it. Some saws with autotmatic oiling will leak bar oil into the cylinder and ...

...chainsaw wont start getting spark. fitted tillotson carburator repair kit, still wont start. starts for a few revs then cuts out.sometimes carb floods out of top hole in carb. have not fitted small ...

...chainsaw wont start. put new plug husqvarna 14" chainsaw wont start. put new plug on plug wire and pulled cord, no fire. what would cause it not to fire? Try a new spark plug.If still does not ...

...wont start I think you are saying it sputters but won't run. Once it attempts to fire open the choke or it may flood. My 359 start: Cold: pull out choke control, pull starter (usually twice) while ...

...chainsaw, wont pull fuel I rebuilt carb new fuel line new intank filter. runs great on starting fluid most of the time there is a air leak in one of the two crank shaft seals.to get to them you need ...

...Wont Run ' Arboristsite.com www.arboristsite.com > Forums > Equipment Forums > Chainsaw Aug 14, 2011 - 10 posts - ?7 authors I have a Stihl MS 180C that i cannot get to run. I used it all last year ...

...wont start Flush out the cylinder by running it with choke off, leave for 5 minutes then try to start again with choke on. Check that the air filter isn't dirty as this can cause too much fuel to be ...

...chainsaw wont start. The chain came off and put it back on but cant get the chainsaw to start. check the position of the safety lever /clutch as there may be a micro switch that will not allow it to ...

to much fuel in cilinder in primimg pips have air and dont wont start Never pull the starter more than 3-4 times under full choke. Pull 3-4 times on choke, push in to half choke and pull, should start