Question about HP PhotoSmart Office Equipment & Supplies
...Remove both cartridges and close the top cover. Plug the power back in. The unit will reinitialize and a message will appear to insert the cartridges. Open the top cover and reinsert the ink ...
Question about HP PhotoSmart Office Equipment & Supplies
...remove the rest of the top cover. Also, once the cover is removed, I could use some guidance. HP support was the WORST experience I've ever had to date (which is REALLY bad). I couldn't find anything ...
...top cover and the cover over the print area or can I just remove it through the access hole? If it's possible to remove through the access hole how do I get the printhead carriage to "unlock" so that ...
remove the two white ribbon connectors just below the top cover. Turn the unit back on. You will get an ink carriage jammed message. Turn the power off and reattach the two ribbon connectors. Turn the
Question about HP PhotoSmart Office Equipment & Supplies
...top cover. Open both ink cartridge cradle latches by pulling each latch forward and then up. Pull the pink pull-tab to remove the clear tape from each ink cartridge. Do not touch or remove the copper ...
...top cover of the printer. 2. Remove the print cartridges. 3. Clean the copper-colored contact points on the cartridges with a damp, lint-free cloth. Use a dry, lint-free cloth to remove moisture from ...
Question about HP PhotoSmart Office Equipment & Supplies
...top cover.After 15 seconds, re-close the top cover and then re-close the control panel cover. The LCD will then display Have you removed Blck? 1 Yes 2 No. The LCD will display this question for ALL 4 ...
Question about HP PhotoSmart Office Equipment & Supplies
...top cover that causes this issue if you look at the left hand lip of the top cover, you should note that it does not meet flush with the top of the control panel, there is a cutout for the lever for ...
...top cover off. hello, have you already turned machine around to look at back of machine, and pulled off the rear cover, sometimes you can get the whole paper out this way. now if you already replace ...
Question about HP PhotoSmart Office Equipment & Supplies
...of screws on the back of the printer. Using a TORK BIT T-10 screw driver remove the two top screws that holds the gray top on. There are several snap connections on the bottom edge of the gray
636 questions posted
Usually answered in minutes!
1,869 Questions
1,438 Questions
900 Questions
484 Questions
488 Questions
