HP LaserJet 3330 All-In-One Printer "change bulb" Questions

Toner Not Sticking Well I have changed the fuser film and pressure roller but the toner does not adhere properly There is a long bulb placed in the centre of the fuser roller below the pressure roller

the cancel button is flashing and it wont change from bulb warming up..not printing clean the scanner,if the problem persist change the scanner unit

...message of bulb error or something like this, you have to change the scanner assembly. contact me if you want a new one with a good price [email protected] or send me the error message ...

...change them and doesnt save for me to try and scan again. It is quite a big problem because letters need to be scanned into the PC after being signed and then they are emailed across the continent. ...

...bulb under the glass. and try this too : Switch off the printer and remove all cables except the power cable. then press and hold the *(start/symoble) and 5 button together and turn on the printer. ...

...bulb blinks on one end. Unplugging sometimes resets to the point it will begin the calibration. Otherwise, it just clicks on powerup. I've removed the bed glass and slid the scanner to the home ...

...change the lamp is a bit complicated job. Error Msg scanner bulb warming up through out pls can you assist me urgently because till today i dont know what to do with the printer coz of the error ...

...change laguage,time,date etc. 3. Remove paper scrap or dust obstructing scanner or sensor. REF 4. Clean sensor / remove the glass and clean the bulb and mirrors. REF turn off power remove ADF and ...

proble with HP laserjet 3330 window shows: Scanner Error Power off/Power on turned off and back on and same problem has occurred 3x help please You will have to have the scanner assembly replaced. ...

change to Scanner Bulb Warming Up as the new firmware initializes. Finally, the display will show Ready in the top-left corner. Depending upon the operating system on the PC, the software might prompt