...output tray is full to capacity do you ntoice when the paper leaves the machine if there is any curling in the paper if this is the case open a new ream of fresh paper and try again also the output ...
...output bin. Printing resumes automatically. Take a close look at the flaps hanging out the exit of the printer. They should move up and down freely. If one of them is stuck up, broken or dislodged, ...
Question about HP LaserJet Office Equipment & Supplies
was jammed so that even though there was no paper in the output tray the printer believed the tray was full. Fixing the jam didn't reset the printer, however, so it was necessary to reboot the printer
...tray before refilling it. Output capacity might have been exceeded in the paper output bin. Do not allow more than 125 sheets of 20-lb (75 g/m2) bond weight paper to fill the paper output bin (less ...
...tray before refilling it. Output capacity might have been exceeded in the paper output bin. Do not allow more than 125 sheets of 20-lb (75 g/m2) bond weight paper to fill the paper output bin (less ...
output bin. When the tray is full the flag will stay activated or in the "up" position instead of down. Telling you to empty the bin. You can see this flag in the center on the delivery assembly(where
Question about HP LaserJet Office Equipment & Supplies
...tray areas 4 Optional duplexer 5 Output areas (top and rear) 6 Fuser area Solving repeated paper jams * Check all the paper jam locations. A piece of paper might be stuck somewhere in the printer. ...
Output Full, empty all bins" - this error does not seem to come up anywhere with suggestions and I have emptied all trays, ensured there is not a paper or piece of paper anywhere stuck in the machine.
Question about HP LaserJet Office Equipment & Supplies
output path with approx one-half to one inch of paper projecting. Jam indicator lights. Removing paper shows printing has completed over full length of paper. please, gradually pull out the paper, off
...Output Bin (The tray in which the printout comes after printing ), check the Black Flaps mostly the left side flaps are bit upward in position in respect to the right one. Kindly push them downward ...
97 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions