Question about HP LaserJet Office Equipment & Supplies
...lever until it stops in the open position. The pickup roller assembly should remain on the surface. Remove the assembly, and then wipe the assembly with a soft, dry, lint-free cloth. Replace the ...
...lever on the roller shaft until it is in the correct position and them reintall the roller. This is sometimes easier to do if you tilt the printer on it's back so you can see what you are doing. ...
...lever on right side and roller comes down see the position of feed roolers in tray 1 they didn't come out cross check them properly & set them in proper position also check the paper path from ...
roller to stop and not complete delivery. Whne paper pulled out by hand about one fourth is held between rolers. But when papers are printed from the lower cassette there is no problem. It was working
Question about HP LaserJet Office Equipment & Supplies
lever might be stuck or broken." For all jam messages, do the following: 1. Remove jammed print media from the specified location. Check the entire paper path for other pieces of media in the path. 2.
...when documents are placed on the ADF. Open the small ADF cover on the top right. There you will see rollers and a paper sensor. First make sure the isn't any paper stuck in the rollers. Clean the ...
...or if they are there at all. As these levers apply pressure between the heat and the pressure roller forcing the toner onto the page. If they are there and in the correct position then the ...
Question about HP LaserJet Office Equipment & Supplies
...lever is set for multiple pages. It use to work but over time it has stopped faxing multy page faxes. You have to hand feed one page at a time one right after another hoping the fax roller graps the ...
Question about HP LaserJet Office Equipment & Supplies
error 13 manual feed paper jam at back of printer The thin black plastic lever goes up and down freely. So what is nex to look at. separation bad and pickup roller
Question about HP LaserJet Office Equipment & Supplies
...roller about 1 inch/2.5 cm down, there is a lever that engages a flag at the back of the printer ( the sensor in case tells the printer that the cartridge is in the printer) check that lever and make ...
34 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions