HP Inkjet 1200dn Printer "reset paper jam sensor" Questions

...continue and after powering down and back up. Is there a button sequence to reset the mechanisms inside? Maybe a piece of paper is covering a sensor and that is why you are getting the error

...reset the printer: While the printer is on, press and hold the configuratuion button and press resume (paper feed) button 3 times. Wait 20 second and press the power button. Disconnect the power and ...

...paper jam anywhere. Unable to reset or remove this mesage. A jam sensor may be stuck or have something stuck on it, causing the machine to think it is jammed. These sensors are normally located where ...

...2 ) clean the sensor 3) check the actuator it might be deformed 4) check proper position of tension spring of the actuator. Some Printer & copier has reset procedure after removing the paper

reset the copier. H5-01 indicates tha the paper sensor is defective in the fusing unit. The only way you can try to reset that one is buy turning the power off, wait 30 seconds and turn the power back

...paper jam. Won't reset. Just flashes the jam icon. Well I would take a can of air and blow off the sensors, especially where you began to have problems. The sensors (over time) become coated with ...

...PAPER JAM. HELP can u explain mean clearly....... restart the machine and then try it........ You need to reset the printer. Start with a reset of the device, do you need instructions? Here is what ...

...and would need to be replaced When you pulled out the jam paper you have to reset the printer if that does not shore it up the sensor is broken inside this unit and will need to be repaired. ...

...Reset button Paper sensor broken; replace paper sensor Drive assy broken; replace drive assyBut before it all please check if any broken paper or another material is in paper path blocking the paper ...

...Paper Jam Reset Have a RICOH Aficio 150. Showed a paper jam in Zone "B." Cleared it out, shut the compartment door,and can't get the "paper Jam" error to clear. Does anyone know the factory reset on ...