...check the drum/s gear, is it wear off, if so change it along with the drum's drive gear at machine base, check also the gears of developing unit my AL-1540Cs Just refille toner but still not ...
developer drive gear, behind the mother board,,,view the two clutch left side clutch is developer drive clutch, open & check the gear. Two things could be 1 check dv unit gear normally gear teeths
...drive for developer. Cannot get solid answer from Dell on part number for developer gear drive assembly. They gave me a part number for the motor, but could not say if it was with the gear drive or ...
...developer (not toner) and recalibrate the machine. SC441: Development motor lock. The development motor lock signal remains low for 2 seconds while the development motor is on. Too much load on the ...
...drive gear. Make sure you don't loose the small flat washer from under where the star washer was. 9. On the white developer roller gear, take the tips of your small wire cutters, and place them ...
...developer unit looking at the drive gear in the back of the unit. Turn the gear and make sure that it turns the mixing paddles without slippage. If it slips, replace the gear. If it turns everything ...
Question about Ricoh Office Equipment & Supplies
developer and put a new toner cartridge and started to work OK but only made 300 copies and now the error red light is ON and the msg ADD toner as well. I got some experience on MITA and Panasonic but
Question about Kyocera Office Equipment & Supplies
...Developer motor MCY 1. To check the motor operation, execute DLP(MCY) by U030 (see page 1-3-34). 2. Check the drive gear can rotate or they are not unusually loaded and, if necessary, replace. 3. ...
...drive gear [D] to work the developer into the unit. Repeat [C] and [D] until all toner is in the unit and level with the edges. 7. Reassemble the development unit 8. Cover the toner entrance hole [A] ...
Question about Sharp AL Office Equipment & Supplies
gear drive train. This noise does not affect the performance of the printer and does not affect print quality. All new fusers are shipped with restraints that keep the rollers separated during storage
68 questions posted
Usually answered in minutes!
91 Questions
33 Questions
27 Questions
26 Questions
23 Questions