Question about Sharp AL Office Equipment & Supplies
...Sometimes the ribbon cable underneath the scanner can bind the scanner if the adhasive has come loose. If you can remove the scanner glass, the ribbon cable can be secured with some scotch
ribbon cable connecting scanner unit to base, it may have come unplugged from socket on circuit board. POWER OFF the unit before you do any work on it. The ribbon cable is one of three found near back
...ribbon cable to the head assembly is damaged or pulled loose. This would explain the first message of the "right cartridge needs adjusting". Check both ends to see if it's come loose and check the ...
...Ribbon Motor Extension Cable Assy (154067-901) into connector P107 on the CMX board. Alternates drive and drag roles when the ribbon reaches turnaround. a) Check resistance on the motor (P107 pins 2, ...
...ribbon cable is one of three found near back hinge of scanner and is hidden underneath the other two. It should drape over the edge of circuit board and then plug into small recepticle on inner side ...
...ribbon cable from the scanner to the main board if the latch is in the correct position. I would securely reseat that cable, bias it somewhat upward. Check the ends of that ribbon cable to be sure a ...
...ribbon cable is one of three found near back hinge of scanner and is hidden underneath the other two. It should drape over the edge of circuit board and then plug into small recepticle on inner side ...
...power source. 6- Reconnect the flat ribbon cables by aligning and carefully pushing into the conectors on the main circuit board. 7- Plug in power source and turn printer on (Printer preparing ...
Question about Sharp AL Office Equipment & Supplies
...ribbon cable may need to be reseated. Do the following: 1. Lift the scanner flatbed. (Open the printer as if attempting to install cartridges.) 2. Look in the back right corner of the 6150/70 for an ...
Question about Sharp AL Office Equipment & Supplies
ribbon cables of the scanner and try again. If error still persist then do a factory reset as per below 1) Switch off the printer 2) Press and hold the Stop/Reset button while switching on the printer
25 questions posted
Usually answered in minutes!
91 Questions
55 Questions
33 Questions
27 Questions
26 Questions
