cut off, it just keeps running and draining out. So it never switches to the wash cycle. The water just keeps running and draining out. It doesn't do this for the large load size. Any suggestions? yes
...to the washer.Another problem could be that your drain hose is too long and it is clogging up at the elbow of your drain line, if so cut of a few inches at a time and try to drain washer ...
Question about GE Washing Machines
cut off at the preset capacity. Water will continue to fill machine without overflowing. It's almost like it is draining and filling at the same time. I noticed that it does not do this for every load
...drain hose , and the drain pump. Finally, ta faulty timer control board can cause the error, you test the control PCB if lid switch and drain system are OK. f-- 05 means ---------------- Water ...
drain hose. If the hose elbow is set at incorrect height the water will be siphoned back inside the tub. Access the drain pump filter (front-bottom access door or trim on most front-loader, underneath
...it gets to the draining stage then it floods every where the drain pipe is not blocked and is secure What's the cause? Thanks Estelle. Has the hose on the sink been cut to allow machine to
Question about Washing Machines
...drain hose. Step 3 - Cut the Power and Water Before you start replacing the washing machine drain hose, make sure to pull the power cord out the wall socket. Better yet, turn off the power supply to ...
drain hose rise higher than tub...is length importand or can I cut it? It can rise a little above the tub but not below. maybe 2 or 3 foot. maybe higher you could try it . It just won't drain if it is
...drain hose. Make sure the end has been open (and cut) and that there is nothing plugging it. If the end is closed, cut the end off. Remove any blockage and let the water drain into the bucket. If the ...
2 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions