Roper RAS8244LQ Washer "solenoid" Questions

machine fills up with water and stops what causes this? There is solenoids that switches on the differents modes of the washers capablities. The timer has a cogged wheel that trips switches which in ...

wont intake cold water... There is a solenoid that opens to allow the cold water to enter the machine...you can check it by using an ohmmeter across the coil..you should have a low resistance reading ...

...are removed, slide the top panel to the back of the machine then lift it off. Check the valve solenoids using an ohmmeter. Disconnect a wire from each of the solenoids then measure the ...

limited water from cold solenoid Intermittent or no water from cold solenoid. Tested solenoid and is working fine. Has anyone had problems with temperature sensor or solenoid drive transistors? ...

...to be taking the water in as normal. We only have it connected for a cold wash. Could this be a solenoid problem indicates that it is so prove it by changing over the hose with the hot water hose ...

...problem can be a lid switch also if the lid switch is bad , it wont send powerdown to the wig wag solenoid . the spin solenoid is mounted on top of transmission , when plunger on solenoid is ...

...doesn't start to fill tub turn tap on---- sorry I thought it Funny water flow is controlled by solenoid valves attached to inside rear wall of washer. usually cold water fails first by the most ...

...washing machine. We have tried removing it, cleaning, soaking,.etc. HI. your model has a dispenser solenoid for the fabric softener dispenser on this unit. If the solenoids are out or

like you could have a short in one of 3 places ? the start button, the timer, or the hot/cold water solenoid. The start button is the least likely so I?d first check out the solenoid. Does this happen

...Top Loader 110.82183110. Just replaced belt and cannot remove inner agitator. Look on the wigwag solenoids. their are 4 wires a white common wire on both solenoids and 2 different wires one on