Roper RAS8445KQ Top Load Washer "replacing idler pulley amana" Questions

Ad

...idler pulley in the picture is behind the motor. I would check the ilder pulley to see if it rotates freely and does not have any odd side to side movements. If it does then replace the idler pulley ...

Ad

Question about Amana Washing Machines

1 Answer

...you are replacing the belt. The small idler pulley can be worked on by running the belt on the big pulley when reinstalling the motor Try not to stretch the spring for the idler pulley, hope this ...

Ad

Question about Amana Washing Machines

1 Answer

left side of black plastic idler pulley. Work belt around transmission pulley. You can press on opposite end of idler pulley arm to loosen belt tension. Make sure belt is on all pulleys before testing

...bearing or coupling to the drum. hope this helps worn clutches replaced the belt, and idler pulley on my ge dryer, but the drum does not turn, it slips on the idler pulley, can i stiffen the

...Idler Pulley Wheel. about a month ago is stopped agitating, now it is not spinning well. the blet looks ok. but is not that tight. there is also a black film on the bottom of the washer under the ...

Question about Washing Machines

1 Answer

...idler pulley free spinning, pump still rotates and works, tub spins. White hex drive under tub pulley is partially raised. Prior to problem a howling noise during the spin cycle after the wash. Do we ...

Question about Amana Washing Machines

2 Answers

idler pulley. Putting the screws back in seemed to go easier than taking them out. I am not a repair tech so just figured things out as I went along. Ther may be an easier way,,, but short of removing

Question about Roper Washing Machines

1 Answer

...assume that perhaps you did not wind hte belt correctly arround the legs of the pump and therefore are not putting the correct tension on hte pulley(remember to hook spring back up to tension

Question about Amana Washing Machines

1 Answer

...always there. as far as not spinning completly you may need to replace the belt or the idler(tension pulley), two 5/16 screw along the very bottom of unit will gai you access to see inside the ...

...idler pulley is fine. the belt should measure 93 3/8' but it measures 95'. the belt simply goes around the drum, idler pulley, and motor shaft right? Hi, Yes, your right about the 93 3/8 length.... ...

Not finding what you are looking for?
Roper RAS8445KQ Top Load Washer Logo

654 questions posted

Ask a Question

Usually answered in minutes!

Top Roper Washing Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Roper Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...