Question about GE Washing Machines
...remove agitator from GE washer? Model WHDRR418G1WW. GE washer will not agitate. Drains OK. How do I remove the agitator to see if it is still connected to clutch/motor? Thanks...Dave how to remove ...
...REMOVE AN AGITATOR FROM A WASHING MACHINE I NEED TO REMOVE THE AGITATOR FROM A GE TOP LOAD WASHER, MODEL NUMBER WHRE5260E1 1 First you must determine the brand of washing machine you have.2 To ...
Question about GE Washing Machines
...remove the agitator ? You should be able to unscrew the top cap of the agitator ( may be left hand thread ) and lift off the agitator once the cap is off... They sometimes stick so you may have to ...
remove agitator on a whirlpool washer, remove top cap from agitator, Next you will find a translucent cap, remove this with your pliers. Then you will see a 3/8 inch nut, Back this nut out and you can
...remove the dust cap above the agitator bolt. I used needle nose pliers, a butter knife and a screwdriver. It seems to be glued down so I tried a heat gun on a low setting to try and loosen the glue ...
Question about GE Washing Machines
remove the agitator from a GE washing maschine? Can get the cap off from top, but than have four little knobs seemingly plastic, but no screws i can remove the top of the agitator but the agitator its
...agitator is not brocken. Remove the soap cap from the top of the agitator and with a torch, look down into the shaft. There is normally a nut which secures the agitator to the gearbox shaft. If the ...
...remove the agitator since a belt is stuck underneath.? There is a shoelace twisted underneath the agitator of my GE S3700G2WW washer. I need to remove the agitator to get it out but I can't see the ...
Question about GE Washing Machines
...in place. If it does, it would be under top removable agitator cap. If there is no nut, agitator snaps off by slipping fingers under agitator at 3 and 9 o’clock positions and pulling up hard and
remove agitator have rusted hole in tub , trying to remove agitator. Tried channel locks , pipe wrench and other tricks to no avail. Maybe I`m doing something wrong model WWA5710 That is a very old GE
301 questions posted
Usually answered in minutes!
517 Questions
101 Questions
108 Questions
50 Questions
52 Questions