Roper REX4634KQ Electric Dryer "changed thermostat fuse working" Questions

...thermostat needs changed too. the thermal fuse is your last safety measure that goes, which means your cycling thermostat is not shutting down the heat element once it detects the right temp hot air ...

...changed the Thermal Fuse and it worked fine 3 loads. However, it stopped again. I did notice the heat was twice what it normally is. Could this mpossibly be the Heating Element?Somthings making the ...

...fuse and thermostat, approximately 1 month later the fuse blows again. I have noticed the est. drying time display change, if set at 41 minutes, a few minutes later the display changes to 15 minutes ...

...fuse burned out mostly due to link block on vent line and preventing the hot moisture air escape. Thermal cut off or high limit thermostat near heating element burned out due to heating element over ...

...changed it. Could the low limit switch which checked OK be the problem, by it not opening does not cycling heater on and off. Thanks. There are two thermostats, a 'limit' or 'operating' thermostat ...

...changed the heating element a month ago and everything was working fine, then it stopped again. i checked the heating element and it doesn't seem to be bad. what other things could i check? Hi, Check ...

changed the the element and the dryer controller and can't find any continuity faults. Also I have been offered a WD71 with a broken condenser, do you know if the WD63 and WD71 condensers are the same

...changed element, still no heat Most dryers have a thermal fuse, which burns out when the dryer overheats, in which case the dryer will either not run at all or stop heating. The fuse is usually ...

...if the thermal fuse goes again change the thermostat also...usually if the thermal fuse is blown there is another part that has caused it...most often it is the thermostat that has gone bad ...

...thermostat need changed or the whole board? Repairman charged almost $200 to change thermistor and thermal fuse and it quit working on the second load I was drying (it did heat for that first load). ...