Zanussi FLA1101W Front Load Washer "timer knob" Questions

Timer Knob Spins - Knob OK - New Timer Purchased Knob Still Spins Previously posted that timer knob on Kenmore Model 110.82891110 was spinning. The knob is not stripped, and can be tightened on the ...

...timer knob Timer knob will not turn timer. It will pull out and in but won't turn thr timer. The timeer can be turned using the ring behind the knob and will then operate normally. I can not set the ...

...timer knob. I am attempting to replace the water level knob on my washer, however, I cannot get the timer knob off in order to replace the part. How do I remove it without breaking it? you have two ...

...Timer Knob I have a Kenmore Series 90 Model 110 Washer with a loose timer knob. The timer itself works fine and when turned with needle nose pliers will run the washer as normal. However, the knob, ...

timer. The knob on my Kenmore Elite (Model 110.23014100) won't move the timer. If I push it in to move the timer it just spins freely. I can pull it out and the washer will start but I need to be able

...timer knob spins Hi - I have a Kenmore Washer, Series 80 model 110.82980120. The timer knob just spins. I did some research last night, and was able to get the timer knob off, but not the dial/guard ...

timer knob I am trying to replace my timer and I can't figure out how to take off the timer knob on the front of the machine. some models you remove center cap on knob and pull pin out others you need

...timer knob in the main control panel. If the timer fails, it can be replaced with just a few hand tools. 1 Unplug the washing machine's cord from the electrical outlet. 2 Remove the two screws ...

...knob, skirt and timer mechanism. Hello: Its either your knob is stripped or the timer itself is..Most commonly its the knob assembly that's bad.(part# WH01X10061) I would try it first since the knob ...

...knob or timer or both? Thanks! Start a cycle and remove the knob. If it still stays in agitation mode and won't advance to the spin, then you have a bad timer, or no power to the timer motor(very ...