Zanussi WJS1397W Front Load Washer / Dryer "bearings going expensive" Questions

When my washer is on the last spin it is very loud, almost like it needs a muffler You didn't say what model washer you have, but it sounds like you have a bad spin bearing. When bearing is bad it can

...and also tried to replace just the bearings and seals. In the end I wasted the money on the bearings and seals and got an new assembly. I'd recommend just going for the new assembly and saving

...going on? The wash drum should spin smoothly by hand without much noise. It is supported with two sets of ball bearings. If the water seal fails, water starts to leak into the inner bearing and they ...

...several of these washers out there with bearings going bad.I cant keep replacing tub every time.getting very expensive i also need the seal, have you found it yet? please post part no. and

going down the highway at 60 mph. The matching dryer had been squeaking and now has begun a thumping sound. if it sounds like a jet plane taking off its the drum bearings and you need to replace these

...tub is being scraped. It sounds loose. It sounds like you need a bearing job. The bearings in the back half of the wash tub go bad. and the washer gets loud .It's an expensive repair. I hope this ...

washer is very noisey while on spin cycle like a bad wheel bearing on a car.. but no error codes? Very sad to say but i imagine this will either be a trapped item such as bra wire caught in the drum ...

When the washer spins, it is making a terrible loud noise. The washer has always vibrated, but this noise sounds more like a bearing to my husband. It also smelled hot at the end of the cycle. If the ...

...bearings are going out. Can they be lubricated? Or replaced Depends on what sort of machine it is. (Front or top load)Bearings can be replaced but this will always entail replacement of all the tub ...

...going bad. If it accelerates and gets slowly louder it is probably the bearings. It seems like defective bearing or pump ,check out pump first if it is not pump problem then it is bearing and you ...