Zanussi FJS1225W Front Load Washer "usually gets cold doesnt" Questions

...usually use cold water only. The screen inside the valve, right where the hose screws onto the machine, may be blocked. If not blocked, check the inlet valve solonoid coil to see if it is open and in ...

usually indicative of soemthing blocking the flow of water out of the soap tray, down the connecting pipe and in to the drum chamber. The soap tray doesnt have any seals as water should just flow into

usually indicative of soemthing blocking the flow of water out of the soap tray, down the connecting pipe and in to the drum chamber. The soap tray doesnt have any seals as water should just flow into

usually indicative of soemthing blocking the flow of water out of the soap tray, down the connecting pipe and in to the drum chamber. The soap tray doesnt have any seals as water should just flow into

COLD electrical connections (RED is usually the HOT water side). Make sure all hoses are fitted back in place and the hose clamps are snug. 11. Re-install washer case. With the lid of the washer open,

...usually more) with relatively no problems and great results. Early on I had a Maytag repairman come out because it kept spinning after it had turned off. He said I used too much product (I used the ...

cold water valves. This screen helps prevent minerals and small contaminants get inside the valve and prevent it from seating and closing properly. If water is just trickling out, this screen could be

cold water supply to the back of the dryer, the water inlet valve is what they connect to. You will have to gain access into the control panel of the washer (the part with all of the selector knobs on

COLD electrical connections (RED is usually the HOT water side). Make sure all hoses are fitted back in place and the hose clamps are snug. 11. Re-install washer case. With the lid of the washer open,