Question about Canon Office Equipment & Supplies
...erreor. Lamp flashes 5 times, reported Operator error. New Cartridges all round, Whats the problem ? Strip out the cartridges, remove the printhead and clean. Reset the printhead and all will be
Question about Canon Office Equipment & Supplies
...lamp open • Power supply board defective This is the reason for the error code according to (printcopy.info) Might help you in some way, but not my area of expertise. enter service mode, push in ...
...error 4h heater lamp&fuse ( broken heater) RESET:clear -interrupt -0-interrupt and 14 start-15 start try the simulation about 5 times if not. u have to check fusing unit. so disconnect the two ...
Question about Sharp Office Equipment & Supplies
error code H401 on my sharp AR336 copier. Help please H 401 means Heat roller low temperature detection. i.e. The temperature does not reach the preset value within the specified time (3 min. in usual
...error code H4-21 -H4-21 means: Sub heater lamp abnormally low temperature detection. The setup temperature (about ?25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from ...
Question about Ricoh Office Equipment & Supplies
...defective or out of position Fusing lamp open Power supply board defective my nashuatec copier series 3913s is showing error 831, how can i remove this? my nashuatec 1805 memory clear ...
Question about IBM Office Equipment & Supplies
...lamp is blinking (flashing) that is the secondary Jam error meaning somewhere in the paper path is a jam. The lamp shoul dbe blinking in a sequense - that sequence indicates what are of the printer ...
error Code H4-21. -H4-21 means:Sub heater lamp abnormally low temperature detection. The setup temperature (about ?25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning
Question about Canon Office Equipment & Supplies
error apears. It is almost like the scanner is not in correct timing with the gear motor. Is this possible? The scanner has only 1 motor and when initializing moves the lamp to the end, where there is
...lamps will be flashing in a set sequence, ie green flashes 4 times and orange 5 times. the sequence of flashing lights is more accurate than the error code.Please come back and tell us what they
79 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions