Question about Canon PIXMA Office Equipment & Supplies
ribbon cable connected to the print head carrier. There is often some sort of locking clamp on that connector. Unlock it, pull out the ribbon cable and clean the contacts on that end, then reassemble.
Question about Canon PIXMA Office Equipment & Supplies
print simple B&W test. I replaced both Black cartidges and it did not help. It used to work fine. The only think I have done recently was to install a old driver for an older BJC inkjet printer when I
...ribbon cable is one of three found near back hinge of scanner and is hidden underneath the other two. It should drape over the edge of circuit board and then plug into small recepticle on inner side ...
Question about Canon PIXMA Office Equipment & Supplies
...ribbon inside got it acting like it wanted to print again. Then the new cartridge finished the job. Ok, I have had this code twice. First time I unplugged both power and computer connection for over ...
Question about Canon PIXMA Office Equipment & Supplies
...print head moved from its original location on the right to the centre. However this time I got the C000 error on the LCD screen. I simply ignored this and followed the instructions to installed the ...
Question about Canon PIXMA Office Equipment & Supplies
print head and unplug the printer with the carriage still in the center of the printer. You will need a medium Phillips screwdriver with a long shaft (at least five inches long). Start by removing the
Question about Canon PIXMA Office Equipment & Supplies
...ribbon between the print head and the ribbon guide, then turn the ribbon tightening knob to help feed the ribbon into place, it shouldn't be twisted or creased. C. Slide the print head from side to ...
Question about Epson Office Equipment & Supplies
...print head and ribbon guide, turn the ribbon tightening knob to help feed the ribbon into place; its not be twisted or creased. select the print head from side to make sure it moved smoothly ...
...print the card the ribbon keeps breaking and I have to wrap it and print again, this happens all the time is there any solution remove the ribbon and make sure the winding is correct. It sounds like ...
...slide to the right (up the printhead) so...when you close, the ribbon is no longer over the sensor....thus the error message. Just try sliding the ribbon to the left (down the print head) as you ...
597 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions