Compaq Presario SR1120NX 2.66GHZ Tower w/ CD-RW (2018267632) PC Desktop "power" Questions

will not power up. monitor is in standby and there is no power on pc. I replaced the cmos battery and reset it. but im not sure it helped because there is no power on the pc. The pc is ten years old ...

Emachines pc will not power up. Outlet that it's plugged into is powered. Suggestion is to bypass the Soft Power On of the Power Supply, and see if the problem is the Power On switch, or the Power ...

My Compaq Presario will not start since we had a power failure in our town yesterday. It seems like it is unplugged, but it is plugged in. Can you help? Can you check if the power is connected to the ...

...reset would help greatly. thanks.. May be you can try to perform partial reset by : Disconnect the power cord from the back of the product, and then wait for 20 seconds. Press and hold # and 3 on

will not power on Try to change your power supply. If the desktop power lead and mains outlet are OK and the power LED light does not light up, then most likely the problem is a fault switch mode ...

...found more than once that One bad receptacle in the surge protector is bad. "Hmmm, surge protector power on light is lit." "Monitor has power, amp for the speakers has power, and the router has

...up, but now just the flashing green light and no fans. At least when motherboard is plugged into power and solid green light when all accesories unplugged!! Was origonally checked out at a local ...

system turns on however hard drive will not cycle nor will mouse or key board activate Turn power off and unplug power from computer. Unplug printers,backup drives and speakers. Open case and unplug ...

my desktop computer wont power on Suggest you see if the problem is the Power On switch, or the Power Supply. (First check to see if the receptacle in the surge protector, that the computer is plugged

will not power on power went off and now I can't power it back on Hello, Chances are your power supply may have gone bad or the power plug may have simply come loose from the power input or wall unit.