Dell 1600n All-In-One Laser Printer "scan copy small large print" Questions

...glass by lifting doc feeder / platen cover and manually placing original. If no line copying or scanning manually from large glass, then small scan glass is deffenitely the culprit. Hope this

...copy at the same position of every and any print while scanning and printing. However there is no unwanted mark whtsoever while printing direct from PC. Also, any scanned image when viewed in the ...

...scan or copy, make sure the smaller glass area is clean along with the rollers.  Test whether it is the printer, print a blank document from a word processor. If no lines, something is messed up ...

...large glass area. Then open the part where the paper feeds in when using the document feeder. It will flip open from right to left. There are two pieces to this, so make sure you grasp it as low as ...

...copy only when printing but copying is ok i.e km 1650 If this only occurs when using the document feeder then you will need to clean the smaller glass that sits next to the large glass that you ...

copy, it prints a line down the middle of the page. If we print, it works fine. Any ideas? I have run the clean drum process and this does not seem to be helping it. No promise that this will work for

...scan glass to copy, the mark on the glass will only show as a spot, but will show as a vertical line thru the whole copy when using the feeder. I have MFC 7820N. Noticed same problem as other when ...

scan and copy only and not when you send a job from the computer your solution is easy to remedy. Try going into the menu located on the printer to info menu. Scroll down to conguration page and click

copy. Its about 1.75 inches from the left margin of the page when the page is fed in top first. I cleaned the glass and its still a problem. Not a problem when copying without the page feeder, and not

copy of the meter reading of the device and this print will come directly from the engine of the device and will eliminate everything that has to do with the optics. If this print looks good(no lines)