to Off using the + (right arrow) button. 5. Press Select. Note: Turning off this option makes it possible to receive a fax when the receiver fax machine does not support certain error correction modes
Question about Dell Office Equipment & Supplies
...fax starts going through there is a brief halt in the faxing sound. Comcast says the baud rate is set too high. How do I change it? To set the receive speed Change RX Start Speed SettingThe message ...
...can change? I didn't see anything in the manual. turn off ECM (error correction). then if problem persists, slow down the fax speed to 9600 bps. this problem always occurs with a digital or VOIP
...fax operation Press a or b to choose Basic or Normal (or High). Basic cuts the modem speed to 9600 bps. Unless interference is a recurring problem on your phone line, you may prefer to use it only ...
...are only 2 speed settings. Since the MJ does not support faxing, if the slower 9600 bps does not work, you will be unable to fax with the MJ. Thanks for using FixYa - A FixYa rating is
Question about Dell Office Equipment & Supplies
...receive faxes just fine, but when I send more than 1 page some pages are ''dropped''and not receoved. Ink new, paper new. Hi. Try to lower the Max Send Speed in the Fax settings to 9600 bps or check ...
...receive faxes without any problems? Make sure the fax line where the printer is connected is working properly. It could be a signal quality in the connection. You can also try to decrease the ...
Question about Dell Office Equipment & Supplies
receive faxes. Machine cuts off after 2 rings. If you are unable to send the faxes, please try decreasing the modem speed and disabling the "Error Correction Mode." To decrease the modem speed, please
...fax transmission speed 9600 bps, as some older fax machines are not capable of receiving a fax at a high speed. To do so: 1. Press the Fax button, then press Options untill u see ADVANCED FAX. 2. ...
...receive and print faxes. When receiving a fax, the MFP 1600n makes the fax noise, and the display says receiving, but nothing prints. Cisco says the baud rate of the fax needs to be lowered. Is this ...
372 questions posted
Usually answered in minutes!
995 Questions
574 Questions
608 Questions
501 Questions
509 Questions