Dell Dimension 4700 PC Desktop "bios jumper" Questions

...jumper plug on pin 1. Replace the computer cover.[Click here] Hope this HELPED you...Thanks for Contacting FixYa... Go into the Dell BIOS, in one of the BIOS page there may be a option to select LOAD ...

...jumper back to the #1-#2 connection. Reconnect the AC power. Restart the computer, and enter BIOS SETUP, and use "Load BIOS Defaults". I believe that you need to set up the CMOS jumpers inside the ...

...BIOS with out a password. Help removing the reset jumper is not enough pleas remove the battery near the jumper for several minutes then return it back then try Typically there are 3 pins where the ...

...jumper near cmos cell u read there " bios reset or clear" It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset. then again set it in 1-2 its original ...

...Bios and press enter. 5. Once again switch off your computer. 6. Reset jumper on the same place and cover your computer again. 7. Start your computer enter into Bios without any password. Now you can ...

...bios reset jumper. (check owners manual or dell website for the location) Dell says to remove for 5 seconds and replace to reset bios. I find this to be incorrect. I had to unplug cord remove jumper, ...

jumper back to its original position. Reconnect the power-cable. Turn the computer on. Can you now enter BIOS-setup mode, without a password? If not, turn your computer off. Disconnect the power-cable

...BIOS Press both mouse buttons repeatedly during the boot Using the Motherboard "Clear CMOS" Jumper or Dipswitch settings Many motherboards feature a set of jumpers or dipswitches that will clear the ...

...bios. There is a jumper near the cmos battery. Most of the manufacturer label the jumper as CLR, CLEAR, CLEAR CMOS, etc. There will be 3 pins and the jumper will be joining the center pin to either ...

...jumper for this . I even looked through the bios setting just in case it might be covered there, no luck. If you can't find an undocumented jumper on the board somewhere labeled something like TRPWR, ...