Belling XOU174 Electric Single Oven "need probe test working" Questions

...t respond. The oven seemed to work fine. Test Continunity for your Probe, if it has good continuity, then you have a internal issue with the Oven... More than likely, you are going to need a ...

...Other items effecting oven element are fuse, thermostat, timer/clock, door switch. You need to follow through circuit with wiring diagram and appropriate testing device i.e. multimeter, neon

...probe to the rating on the gas valve to see if you have enough current. (typically you need 3.2 amps for most systems). As ignitors get weak the resistance in them gets higher causing the amp draw to ...

...butwhich I take as the unit trying but won't move up in temp? maybe a faulty temp probe or element I just dont know, HELP ME!! Hi. Probably faulty element, but you would need to test it to be

...need a volt ohm meter for the following.. Test the Element for continuity. Place each probe on the terminal ends (manual will have ratings) generally if you have continuity it probably works.. Test ...

need to see if supply voltage is correct. Verify oven probe sensor to the thermostat Is working properly? (usually done by Ohm test) Thermostast offer an option for calibration? Also have you verified

...test operation of switches. FDShorted meat probeProblem could be with the probe, the receptacle, or probe circuit. Check probe. Look for pinched wire. Look for condensation or contamination on probe ...

...need to replace the lower element. Before replacement the element can be tested removing it from the cavity and reading Ohms at the element terminals, with a multimeter set at Rx1. Disconnect power ...

...probe. They are easy to test and easy to replace. Some have to be removed from the back. This may involve removal of as few as two screws up to removing the back panel.. a fairly simple repair once ...

...need to read oven temperature sensor circuit at oven temperature sensor ( approx 1000 ohms at room temp); check for cut or pinched wire or loss of contact, if wirings are ok, then replace the probe. ...