Dell Dimension 9100 PC Desktop "not turn" Questions

...not turn on-no power-it turn off during a thurderstorm-try to turn it up again but did not-did not try to turn it up again until months later-it did turn on-used it for about 2 hrs-did ok-turn it off ...

...not turn on. Steady Amber Light My Dell Dimension 4600 will not turn on. I plug it in, and the power light stays orange. I cannot turn the PC off by holding the power button, and nothing shows on the ...

...turn on or not, just proceed until you finish connecting all of the device or until you pin point the root cause of the issue. 4. (From step 2 ) If it didn't turn on, Open up your computer tower and ...

...not turn on The button to turn on was taking a few pushed to turn on. Once it started all was ok. It finally just stoped turning on. There is a yellow/orange light blinking on the buttin but nothing ...

...not turn on. it's like its not plugged in but it is and there is power to the power source. I use a surge protector incase of power surges. It was working fine. just all of a sudden it will ...

...turn on. When power button is pressed it makes a buzzing noise like it is trying to power up. Instead of the power light turning green, like normal the power light stays orange, which I have not seen ...

not available to protect your devices etc and in turn a lightening strike close enough will fry the computer due to EMP ( Electro Magnetic Pulse )You may need to have a qualified person look at it but

...Not Turn On Installed MS "Care - Live-One" After it was installed, I found the firewall turned off. Attempted to turn-on through the Live-One features. It would not highlight the on button. Found the ...

...not, try to turn off the system and open the case. Look for CMOS battery on the motherboard and disconnect the same Wait for about five minutes and reconnect battery Turn on the system. If it remains ...

...not turn on I have a Dell Dimension 5100. This morning the tower would not turn on. I checked to make sure the surge protector was working and the power cord was connected properly. I cannot figure ...