Epson Aculaser C1100 Printer "cause white screen gear" Questions

...cause that we have found on these particular models is the waste toner auger (built in the drum unit) drive gear breaks due to blockage or failure of the auger. You can remove the drum unit by 1st ...

...cause. As others had pointed out before, it can have a lot to do with some obstruction in the print path, the gears, or ink on the clear plastic encoder strip. You're on the right track - I found the ...

...cause. It can have alot to do with some obstruction in the print path, the gears, or ink on the clear plastic encoder strip. You're on the right track - I found the the purge cap (the white sliding ...

...screen warning said to remove jammed paper and the printer showed an E3 error. The problem was caused by the ink cartridge carrier becoming stcky on its track and not fully returning to the rest ...

cause it. Since this is a new printer, maybe there is some packing or packing tape that is obstructing the carriage. Verify that the carts and printhead are installed properly. Check the gears as best

screen says it is shutting down but it doesn't. I turned it off by shutting down my PC, then rebooting - I now have a message which states: "To avoid damage use the on button to shut down the printer.

screen displays Print cartridge cradle is stuck / clear jam and then press OK . The printer may also make grinding sounds. This can occur after a paper jam when another printer part blocks the cradle.

...Screen removes a bunch of stuff from that bar, but it still has to be there so it can rotate during startup to trigger the sensor). - Power off the printer. - Remove the front stainless trim panel ...

white, flexible plastic flap. The document guide should be tucked in behind the grey plastic casing, but a paper jam can push it out of position. Figure 8 below shows the correct (1) and incorrect (2)