Dyson DC14 Bagless Upright Cyclonic Vacuum "belt roller" Questions

...belt indicator light, the roller will have a magnet built onto one end of it. It's very important to install to install a roller with a magnet on the same side as the indicator light. The roller ...

...roller and old belt 3. install new belt on motor spindle first and then on roller. 4. pull roller, stretching belt, set into roller cavity. 5. turn roller by hand to center belt. 6. reinstall bottom ...

roller and belt.lift up on the roller and put it on the side .you must clean the old rubber left on the motor shaft first before installing the new belt.otherwise the new belt won't last long.slip the

damage, assemble the belt over the roller and motor shaft, then install the roller into the base making sure to twist the belt if required. Look for a guide diagram cast into the base. Hope this helps

...belt over the roller then put the belt on the motor shaft first and pull the roller towards the front and slip it in the slots or you can put the roller with the belt on it and put the roller in its ...

...roller and belt. Wrap the new belt around the shaft of the motor and slide the brush roller inside the loop of the belt. Use the brush roller as leverage to stretch the belt out and slide the brush ...

roller through belt and rotate the roller while pushing it through belt until it is inside the belt, then continue rotating roller and sliding it over until belt is in position over gears on roller. 5

...belt Remove roller from it's compartment Install replacement belt (hooking it around the motor and roller, using the roller for leverage to stretch out the belt until you have the roller in it's ...

...belt over the roller brush and seat the belt in the groove in the center of the roller. 7Slide the roller brush back into the grooved mounts on either side of the housing and snap into place. 8Pull ...

...roller. Remove old belt. Slide new belt over the motor pulley, first. Then slide roller through new belt (if self propelled model, slide roller through the small belt, also) and slide brush ...