Dyson DC07 Animal Bagless Upright Cyclonic Vacuum "putting wand back" Questions

putting the wand/handle assembly back together and getting everything to click. In a nutshell, the metal tube pretty much just slides back into the tube top, and then the slid-in tube clicks back into

...back part of the wand or cover will now slip off. push it toward the gap. then up. after removing the cover. you will see a ribbon strip which is attached to the prongs or fuse .you can remove the ...

press the two tabs to release the wand out, then take some spay cleaner of any kind and wipe down the wand tube. This should make it easy to slide in and out of the hose. Now just put it back together

...WAND AND SLIDE HOSE UP AND DOWN, AS FOR THE CAP, TAKE A PAIR OF PLIARS, GRAB HOLD OF END OF CAP AND PULL CAP FULLY OUT OF THE HANDLE,AT THIS POINT CHECK THE SPRING OR REMOVE THE SPRING IF YOU PREFER ...

...wand. If you cant see anything coin etc put hose back on machine & switch on there should be good suction from the flexi hose, Now with machine still switched on push alloy pipe back on if the hose ...

...with sort of point that moves when wand is pushed down. It is probably in the wrong position and needs to be reset. Unscre the one screw holding it on, let it flip to the other side. Put wand back

...wand back in it should fit like a groove type. my miele was having same problem and i realized you cant just put wand in any way, doing so could bend one of those plastic strips making it hard to ...

...wand should then be pushed into the slot on the back of the machine until you hear a click. If you don't hear the click, it will come out. I hope this helps. If this does not do it for you, please ...

...wand was back to normal, but it quickly lost suction again. (Within minutes of use) I checked the filter, it seems fine. Again, it worked better, then lost suction again after a few minutes. your ...

...back part of the wand or cover will now slip off. push it toward the gap. then up. after removing the cover. you will see a ribbon strip which is attached to the prongs or fuse .you can remove the ...