...brush bar from the bottom of the Dyson, this means pulling the bar out of the drive belt. This is not to difficult just use a little muscle as the belt will stretch. Once the bar is out grasp hold of ...
...brush and under the belt and make sure the bar is positioned in the vacuum properly and turns easily. Your problem could be the clutch unit what has probably happened is either the clutch plates are ...
brush bar does not turn & makes a loud noise While using the dyson (pet model) it started to make a loud noise. I looked & discovered the brush bar was full of hair! I removed the bottom panel to ...
bar" (or brush roller) not rotating is a broken belt. The number two cause of brushes not rotating is that something is jammed & wound around the roller, preventing it from rotating. For the belt:
Brush bar can't spin Dirt Devil Featherlight Bagless Upright: Brush bar will not spin; I can't even force it to turn an inch with my hands. It's as if it's seized somewhere inside. Just replaced the ...
...brush turn easily when belt disconnected from motor. Belt in good shape. Seems like a good bit of arcing at the brushes of the motor, but I don't know what is normal. The motor shaft is hard to turn ...
...bar & feel suction at the tube were the bag connects, you know you've got it all and you should be unclogged. Put it back together and you should be ready to roll. HelloHello Leslie, First, check ...
...removed string. Not the brush bar is not spinning. Remove the bottom plate to see if the belt came off of the motor shaft, or perhaps it broke in two when the brush stopped turning. Hope this
Question about Dyson Vacuums
...stops. Repacked clutch, beater bar and have no clogs. you need to change the clutch assembly and beater brush not sure what you mean repacked Dyson clutch belt assembly for DC07 amp DC14 900252 04 ...
1,047 questions posted
Usually answered in minutes!
1,132 Questions
836 Questions
655 Questions
597 Questions
450 Questions