...bar is bad. If the brush doesn spin, and it continues to break belts, this means that the belt is being installed incorrectly, and is being pinched by the roller brush. Pull the belt forwards after ...
...bar will rotate the correct direction (as if drying to pull the vacuum forward). Twisted the wrong way, it'll rotate the opposite direction. Try it one way, then bump the power switch to verify that ...
Question about Vacuums
...brush cover (3 screws, quarter turn to install or remove) and see if you have an earlier model or newer model. Earlier models are direct drive. One belt connects the motor to the brush. The newer ...
...brush will not spin, but the motor works, either the belt has come off of the motor shaft, the belt is worn past it's useful life, or the beater bar has seized. 1. Turn off the power (unplug). 2. ...
...bar won't drive The first thing to check is make sure the belt is not broken or stretched. It is possible that a vacuum cleaner may need a new belt even if you just bought it. It may have been a year ...
...brush end. On a 7901, after your remove the side access door you turn the machine upside down, find a red plastic retainer held in with a phillips screw. Remove the screw and carefully pull out the ...
...bar motor will not engage/turn on. The most likely problem is something was not put back together properly in the clutch. You can move the belts by hand with the clutch out of the machine. Move the ...
Question about Vacuums
...brush bar and still got same problem when vaccuming on carpet the brush bar stopa after about 3 or 6 pushes. You probably have a clog somewhere, it turns off brushroll to protect the motor from ...
884 questions posted
Usually answered in minutes!
1,132 Questions
870 Questions
836 Questions
597 Questions
450 Questions