...brush bar. Two possible faults: Debris (hair etc) caught in brush bar - cut out with knife. Or - damaged drive belt - pieces of belt striking casing. Last, but unlikely cause, debris in bearings of ...
...inside the machine. Move the belt over a bit and you will see that a plastic guide has been bent over and is pressing onto the brush, which causes the noise. Just bend it straight again and it
Question about Vacuums
...bar / brush. Both the drive shaft and beater bar / brush that are contact with the belt must be clean. Oils, etc. can interfere with the grip on the belt. If the belt is squealing for very long, the ...
brush bar out of the vacuum. Once removed, we pulled the black plastic end off of the center rod. We discovered hair wrapped around each end of the center rod. After the hair was removed and the clean
...brush bar ocasionally stops spinning. Hi there SmartAlec from NelsonVacuums.com.au here. The rattle is the clutch engaging. It can happen for a couple of reasons. The best case for you is if there is ...
bar is coming in contact with the housing somehow. Unfortunately, you may need a new brush roll. Read this review and see what you think. click here if you have caught anything like shoes laces in it.
Question about Dyson Vacuums
...brush bar. You're missing something. One of three things is happening- There's either something caught up/wrapped around the brush bar, causing it not to move, like a long string wrapped around it a ...
brush bar no suction available. Have looked to see that all airways (u-bend) are clear. When engaging the brushbar the brushbar turns but no suction to floor. Hello, There are several things that this
...bar. After my last project the motor almost won't engage. Sometimes there is no sound, and sometimes there is a weak whirring, but no action until I push the hand wheel. I have a feeling that it is ...
884 questions posted
Usually answered in minutes!
1,132 Questions
870 Questions
836 Questions
597 Questions
450 Questions