...Remove the shuttle cover. At the shuttle frame assembly, disconnect the hammer bank logic and power cables. Power on the printer. If ?HB NOT INSTALLD? appears on the LCD, replace the shuttle frame ...
...shuttle assembly must be removed. You might want to go the printer properties and look for a option called gutter. Increase the value of this setting. This tells you the distance that should be left ...
Question about IBM 6400 Office Equipment & Supplies
...off and check cartridge path. Make sure you have the correct cartridges and that the tape has been removed. You can try a new set of cartridges and see if that solves your problem. I hope this
...Remove the mounting screws from the old hammer spring assembly. (See Figure 18, page 367.) 6. Handling the hammer spring assembly by the mounting base only, gently pry the old hammer spring assembly ...
Question about IBM 6400 Office Equipment & Supplies
...Remove the shuttle cover assembly (page 357). 3. Loosen the platen open belt (page 415, steps 2, 3, and 4). 4. Raise the forms thickness lever (1) to the fully open position. 5. If you are adjusting ...
...Remove the shuttle cover assembly. (leave the screws in the cover itself when you remove it). On the middle-right side you will see a cover sensor -- you will need to fool this with a magnet.Run a ...
8 questions posted
Usually answered in minutes!
82 Questions
13 Questions
13 Questions
3 Questions
2 Questions