Tecnik 24 in. TKD795/3 Built-in Dishwasher "mean light comes goes" Questions

...button flashing When I hold it together I get the same result. No mater what lock light comes back on. It sounds like the circuit bontrol board is cracked or shorted, which means it must be

light goes out when you attempt to close the door. Light out means there is no circuit through the door lock mechanism so the dishwasher will not work. Take a look at the lock with the door open, make

...the lights will come on reseting the board.. push cans. and your done if this happens again that means you have a bad heater or bad ...

...light,when yuo push start goes straight to cacel and drain,you here the drain pum going then will shut off,no water in bottom It is likely there is some fault with the float switch. Which means the ...

...goes through pre-wash but stops with just the 'Delicate' light flashing. Does anyone know what the problem may be? If the original light flashing that means it indicate a fault in the heating ...

...light, then goes out after a few minutes..When I push "normal wash" I can hear something come on inside, but after a couple of minutes, it shuts off... I had a similar issue with my MDB5130AWW. The ...

light comes on and just blinks. I have tried several different wash types, etc, but it just doesn?t start. It obviously isn?t a power issue because the light comes on when I push the start button. The

...mean ? my indesit idl500 starts to run and then stops and the 1st and third light flash . whats it all about ? I have an Indesit IDL 500, the machine will start fine but after about 20 mins the Ist ...

light (prog 45 degC wash) flashing is a code to indicate leak sensor active. Other prog lights flashing indicate a different fault, the following details each... this is a cut/paste from another forum

...light normally goes out. It now flashes 7 times, pauses for a few seconds and then starts the 7 flash cycle again. I've tried pressing every button to cancel it out. I've shut off the power for about ...